These fitting instructions are for guidance purposes only and is one of many methods of installation. If you are unsure please do not hesitate to contact us.

1. Clean the area of the surface that you want to apply your sticker to, removing any dirt or dust.

2. Stick the vinyl in position with a strip of masking tape along the top edge of the sticker.

3. Using the taped edge as a hinge, lift the sticker up and carefully remove the backing sheet from the application tape leaving the vinyl still attached to the application tape. (Assist with knife when necessary)

4. If you are applying a small sticker or large interior stickers, dry application will be fine so proceed to step 6.

5. If you are applying a larger sticker to a gloss surface (windows or car bodywork) it may help to spray the surface lightly with water (you can never have too much water) this will allow you to easily squeegee any air bubbles out.

6. Holding the application tape close to the surface at a slight angle, starting at the taped edge, apply pressure with a squeegee (or credit card) from the top down to flatten the vinyl to the surface, squeegee any air bubbles or remaining water out.

7. Carefully remove the application tape from the vinyl, keeping it flat to the surface and at a slight angle, leaving the vinyl behind.

8. Any air bubbles can be removed by pricking the outer edge of the bubble with a sharp knife or pin. Squeeze out the air or water towards the hole with your finger. As the vinyl matures it shrinks slightly and also breathes so small bubbles tend to disappear by themselves after a few days.

9. If you have used water, carefully dry the vinyl with a soft absorbent cloth or kitchen towel, it may still move until fully dry so take care.

10. Stand back and admire your handy work!